VA skimmer, 215 × 160 mm, for liner pools

Quality skimmer from Spain for sturdy in-ground pools made of plastic, permanent formwork, liner and fibreglass. Also applicable for above ground pools, but due to its dimensions it already stands out quite a bit.

Warning this skimmer is shorter and the body may not come out past the permanent formwork, it is important to measure. Generally speaking, it can be used where you use a formwork with a max width of 20cm.

The skimmer is made of high quality plastic and the screws have brass counter-nuts which will resist corrosion for years and there is no cracking of the plastic.

For flow rates up to 16m3/h.

Made of ABS plastic with UV stabilisation.

Connecting the skimmer to the filtration system

Below the skimmer has two outlets, you choose one and  connect with a 2" nipple or union. You plug the other one with the enclosed plug and gasket.Then you connect the 50mm pipe and proceed to filtration.

For complicated installations, the skimmer also has a 63mm diameter outlet down the side for gluing. Here, however, the plastic knockout must be removed to open this outlet.

Attaching the skimmer to the pool wall

On the permanent formwork you will only concrete the neck, the skimmer body will stick out behind the pool. The larger hole (45-50cm wide, 40cm high) should be omitted and the skimmer concreted. It is recommended to tape the threads before concreting to prevent mess from getting in. Set the stripped-down skimmer body in concrete, without gaskets, flange or other removable parts.

Skimmer Installation - Instructions

The skimmer comes to be placed in the top of the pool, near the filtration. Always install the skimmer, if you can, opposite the return nozzle to ensure circulation of the water. The skimmer collects debris from the pool surface, so it is imperative that it is placed at the top, the level is then about half or top third of the skimmer.

HOW TO CONNECT THE POOL CLEANER:

In order to use this feature, it is necessary to close the bottom outlet valve so that all the pump suction goes through the skimmer. Then the suction cover - disc is placed on the basket and secured by the retaining tabs. As a final step, the hose is attached to the suction cover. If the pool has more than one skimmer, all but one of them, which will be used to connect the vacuum cleaner, must be closed.

Image	Product name	Price	Action
	1) VA skimmer lid collar – top cover	284 Kč	Detail
	1) VA skimmer lid	257 Kč	Detail
	2)Vacuum plate for 17.5 l skimmer – 20.8 cm	287 Kč	Detail
	3) Basket for VA or Astral 17.5 l skimmer	189 Kč	Detail
	4)VA skimmer access lid extension	189 Kč	Detail
	8)VA skimmer weir flap	219 Kč	Detail
	10) VA skimmer frame and flange (short and extended neck)	799 Kč	Detail
	9)VA skimmer gaskets 210 × 160 mm (2 pieces), short and extended neck	468 Kč	Detail