Pump impeller seal iWP
Pump impeller seal iWP. Restores the seal at the specified pump joint. The profile, dimensions and installation point must match the original; a similar-looking O-ring may not seal correctly.
Part code: FIWP0015.
Pump impeller seal iWP
Restores the seal at the specified pump joint. The profile, dimensions and installation point must match the original; a similar-looking O-ring may not seal correctly.
Advice from a pool technician
Clean the groove before fitting and ensure the seal is not twisted. Only use lubricant suitable for the seal and recommended by the manufacturer.
When to replace this part
Replace a hardened, cracked, distorted or flattened seal. Inspect the mating surfaces too: a new seal will not repair a cracked housing or damaged thread.
Identification and compatibility
Pump impeller seal iWP
Catalogue code: FIWP0015
Position in the relevant exploded view: Rapid X20 iWP: 15
Match the full code and design to the original part. A drawing may cover several pump ratings; inclusion in a range does not mean every part fits every model. The named component or assembly is supplied; other items shown in the exploded view are not automatically included.
Replacement and checks
Disconnect the pump from the power supply, prevent restart and release system pressure according to its manual before opening it. Clean the mating surfaces and inspect adjacent components. Reassemble according to the specific pump instructions. Prime and vent the pump before restarting, never run it dry, and check the repaired area for leaks.
Location in the assembly
The original exploded view is an assembly illustration. Use the position and part code above to identify the item.
Product rating
Be the first who will post an article to this item!
Discussion
Be the first who will post an article to this item!